Don't let the exiguous carbon steel metal to close with motor when fixing, it breathes inside motor by magnetic field then cause the motor to set up or cause the winding short
Please use the stainless steel screws when fixing the motor, and the length of the screw is higher than the pedestal, lest to breach the wire
Motor temperature should not exceed 90 degrees
Configuration characteristics:
Magnet: N38H
Silicon steel: 0.5mm
Bearing: NMB
Shaft: carbon steel
Guide wind system: free cooling
Insulated material: somar epoxy (Japan)
Test condition:
Voltage: 11.1V
Propeller: EP1047
Load current: 12A
Net thrust: 720g
Room temperature: 25 degrees
Run mode:
5 minutes on
2 minutes off
Reliability testing:
Shaft direction gap: 0.05 to 0.2mm
No-load noise: 30dB
After testing 100 circle
Net thrust: 715g
Current: 12.2A
Temperature rise: 85 degrees
Shaft direction gap: 0.1 to 0.2mm
Run mode:
5 minutes on
2 minutes off
Accessories:
Front prop holder
Rear prop holder
Cross motor mount, L motor mount, L stick motor mount (see attached drawing)
Key Contact:
Ms
Qin,
Candy
Marketing Manager
Marketing Department
Mr
Li,
Charles
General Manager
Supplier and product information updated July 02, 2008. Global Sources verifies information published here via regular supplier visits.
This member has been verified by Global Sources.Learn more Verified suppliers are visited by Global Sources at least 3 times before their products are listed. This ensures that information on suppliers and products-on-offer is accurate.
